5 Feb
2012
5 Feb
'12
8:35 p.m.
** Paul Tansom <paul(a)aptanet.com> [2012-02-05 20:27]:
** Paul Stimpson <paul(a)stimpsonfamily.co.uk>
[2012-02-05 20:18]:
** end quote [Paul
Tansom]
Bah, forget that my brain is far too into my ADSL configuration having just
been changing it!
I note your default gateway is 85.119.80.1, whereas mine is set to 85.119.82.1.
That said, the documentation quotes the one you are using, so arguably mine
shouldn't work, but it does!!
This will really teach me not to try and be helpful when I'm feeling lousy and
should really just put the computer down and go to bed!
--
Paul Tansom | Aptanet Ltd. | http://www.aptanet.com/ | 023 9238 0001
======================================================================
Registered in England | Company No: 4905028 | Registered Office:
Crawford House, Hambledon Road, Denmead, Waterlooville, Hants, PO7 6NU
Due to a punishing workload, I left my
renumbering to the last
minute and it's not worked right.
Here is my new /etc/network/interfaces:
** end quote [Paul Stimpson]
Your netmask on eth0 is too wide ranging, I'm guessing it should be
255.255.255.248 to cover a block of 8 IPs on the server. auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
address 85.119.82.73
netmask 255.255.248.0
gateway 85.119.80.1
auto eth0:1
iface eth0:1 inet static
address 85.119.82.67
netmask 255.255.255.255
auto eth0:2
iface eth0:2 inet static
address 212.13.194.73
netmask 255.255.255.255
auto eth0:3
iface eth0:3 inet static
address 212.13.194.67
netmask 255.255.255.255
ip -4 addr show dev eth0
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP>
mtu 1500 qdisc
pfifo_fast state UNKNOWN qlen 1000
inet 85.119.82.73/21 brd 85.119.87.255 scope global eth0
inet 85.119.82.67/32 brd 85.255.255.255 scope global eth0:1
inet 212.13.194.73/32 brd 212.13.194.255 scope global eth0:2
inet 212.13.194.67/32 brd 212.13.194.255 scope global eth0:3
ip -4 route show
10.26.0.2 dev tun0 proto kernel scope link src
10.26.0.1
10.26.0.0/24 via 10.26.0.2 dev tun0
85.119.80.0/21 dev eth0 proto kernel scope link src 85.119.82.73
default via 85.119.80.1 dev eth0
/etc/resolv.conf
nameserver 85.119.80.232
nameserver 85.119.80.233
I can still ping and ssh the old 212 addresses. When I'm logged in,
I can't ping 85.119.80.1 and dig says that there are no DNS servers
available. I can ping both 212 addresses from outside but neither of
the 85 addresses.
I'd be really grateful if someone would point out my stupid and
obvious mistake.