[...] Does anyone here use Andrews & Arnold with linux PPPoE and has a ... I've been asked to share. I use debian. /etc/ppp/peers/aanet: # cnw: connect to aanet user [your aanet username] plugin rp-pppoe.so eth1 noipdefault defaultroute #usepeerdns <----- uncomment this if you want resolv.conf to be set up automatically hide-password lcp-echo-interval 1 lcp-echo-failure 10 #connect /bin/true noauth persist maxfail 0 #holdoff 120 <---- this will cause pppd to dial once every 2 mins else default is 0 sec mtu 1492 noaccomp default-asyncmap +ipv6 ipv6cp-use-ipaddr ipv6cp-accept-local ipv6cp-accept-remote "ip addr" should show a v6 link local on ppp0: 7: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1492 qdisc pfifo_fast state UNKNOWN group default qlen 3 link/ppp inet [your ipv4 addr] peer [aanet ipv4 addr]/32 scope global ppp0 valid_lft forever preferred_lft forever inet6 fe80::35e2:b75a:e9b2:a690/10 scope link valid_lft forever preferred_lft forever cat /etc/ppp/ip-up.d/aanet: #!/bin/sh # cnw: delete previous default routes and set up new one route delete default route add default dev $PPIF iptables -t nat -A POSTROUTING -o $PPIF -j MASQUERADE ip -6 route del default ip -6 route add default dev ${PPIF} exit 0 on startup I run a script that - amongst other things does this: ip -6 addr add [an ip6 from my aanet block]/64 dev eth0 radvd -C /srv/radvd.conf cat /srv/radvd.conf interface eth0 { MaxRtrAdvInterval 20; MinRtrAdvInterval 10; prefix [my aanet assigned ipv6 block]/64 { AdvOnLink on; AdvRouterAddr on; AdvValidLifetime 60; AdvPreferredLifetime 59; }; RDNSS [my ipv6 local dns server] { }; }; I verify routing by pinging aanets dns servers: PING aadns(aadns (2001:8b0::2020)) 56 data bytes 64 bytes from aadns (2001:8b0::2020): icmp_seq=1 ttl=60 time=14.6 ms 64 bytes from aadns (2001:8b0::2020): icmp_seq=2 ttl=60 time=13.9 ms if you are running bind & isc-dhcp-server it needs adjusting, e.g. in my case adding ipv6 to allow-query to bind and various other minor tweaks. Hope that helps, Conrad