Hi, As previously discussed on the users list: https://is.gd/wvBvEn …everyone's booting method has now been changed to pvgrub2. The short summary is that it will look and behave more like GRUB now (because it *is* GRUB), and you can expect a typical GRUB2 configuration in /boot/grub/grub.cfg (/boot/grub2/grub.cfg on CentOS 7.x) to work now. More details at: https://tools.bitfolk.com/wiki/Booting If you think you may have reinstalled your VPS using the rescue VM and changed its architecture in the process, it is important that you check that we know the correct architecture. You can see what we think your architecture is by: - Typing "arch" in the Xen Shell. - Looking at https://panel.bitfolk.com/account/ where it is listed next to what we think your operating system is. If your architecture is set incorrectly then your VPS will not boot. If the bootloader appears to detect the correct configuration file and kernel file but still says it can't load it, then check the architecture first. As far as I am aware the only way you could have got a VPS with a different architecture to what we think you have is if you installed it manually through the rescue VM. The supported installers only install the matching architecture. If you checked that and it's correct but your VPS still does not boot, do not panic. Contact support and we can revert you to pygrub until we figure out what is wrong. But having tested many configurations of VPS now, the only failures encountered so far have been trying to boot a 64-bit kernel with an i686 bootloader or vice versa. Cheers, Andy -- https://bitfolk.com/ -- No-nonsense VPS hosting _______________________________________________ announce mailing list announce(a)lists.bitfolk.com https://lists.bitfolk.com/mailman/listinfo/announce _______________________________________________ users mailing list users(a)lists.bitfolk.com https://lists.bitfolk.com/mailman/listinfo/users